Bespoke plaster mold making service selling moulds made to customer requirements in the greater Auckland area and New Zealand wide from supplied models.
Models need to be of permanent materials and in good condition. However, where poor quality models are all that is available, I may have to seal or repair them before work can begin. Poor models don’t make good molds. So this will be a part of the cost to the client
Slip cast and pottery press molds and mould redemption work – new molds off damaged molds, some model making undertaken.
Quality Molds. I make from best mold making plaster with care and attention to detail.
I make second and subsequent molds at a reduced cost to the first mold if made at the same time as the first mold.
Estimates of cost. I require to see the model in order to give estimates. However, in the first instance a photograph may suffice
Where a mold exists – but is worn, and the model is available
I can often to achieve a satisfactory result without having to go back to the beginning and this will reduce the cost. Worn mold and model required.
You have lost the model but have a mold in good condition and require additional molds.
I can achieve a new mold where an existing mold exists and is good condition, but the model has been lost,
Mold redemption damaged model. New Mold required
In these cases, I may have to repair the model before mold making can commence. However, restoration of the model may incur an additional charge.
Mold redemption – damaged molds, no model:
I can often achieve results in this complex process. Save all pieces and crumbs, send pictures initially so I can assess, and if redemption is possible, I will require all parts of the of the mold.